Mentone is a town where a lot of the housing stock was built before modern electrical loads were part of the picture. Older homes on larger lots, properties that have had rooms added over the decades, outbuildings wired at some point by someone who may not have documented what they did. That combination shows up in the calls we take: panels that are running out of room, circuits that were never designed for what they are being asked to carry, and wiring that has simply reached the end of its useful life. We handle all of it, from a single outlet that stopped working to a complete service upgrade.
Homes across this area have every kind of panel and circuit in them. If you are in Mentone and something in your electrical system is not working the way it should, we scope the job on the call and get it scheduled. We are open 5:30 AM to 10:30 PM every day of the week.
When power goes out or behaves strangely, the first question is where the fault sits. The utility owns the lines coming in and the meter. Everything from the service entrance into the home is on the homeowner's side, and that is where our work begins.
Partial power loss, one leg of a panel going down, flickering that tracks back to the service entrance rather than a branch circuit, these can look the same from inside the house but point in different directions. We work through the symptom on the call and help you figure out which side of the meter the problem is on. If it turns out the fault is with the utility's equipment, we tell you that clearly and explain what to report and to whom. If it is on your side, we scope the repair and get it on the schedule.
That clarity matters before any work is booked. A repair that starts on the wrong assumption costs time and money. We trace the fault. We fix the wiring. We restore the power.
Electrical pricing is not a flat number because the job is not a flat thing. The same symptom can lead to a breaker swap or a full circuit replacement depending on what is actually going on behind the wall. Two factors move a quote more than anything else: what the fault turns out to be once it is properly diagnosed, and whether the existing wiring or panel can carry the change without additional work.
Opening a wall to reach a junction box is a different job from replacing an outlet on the surface. Adding a dedicated circuit for a new appliance is straightforward if the panel has room. If the panel is already near capacity, the scope expands. We explain all of that on the call before anything is committed.
You describe the situation, we work through what the job likely involves, and you get a price before a visit is booked. If the job needs a look before we can give a firm number, we say so and explain what the visit covers. No-pressure estimates, priced up front. There is a fuller write-up on our electrical service list.
Booking a visit starts with a call. We confirm what the schedule allows, agree on a time, and the work gets done. For most jobs that is the whole picture. For tenants and businesses that cannot shut down a space, we work around what the property needs. A landlord coordinating access on behalf of a tenant, a small business that needs a circuit repaired without closing for the day, these are common situations and we handle the scheduling accordingly.
Urgent calls are taken alongside scheduled work. If a fault is active and cannot safely wait, call and ask what the schedule allows. A burning smell near a panel, an outlet that sparked and stopped working, a breaker that will not hold reset after a load event, none of these are situations to leave overnight. We take short-notice work and respond to calls that come in across our full operating hours.
Prompt response, even for last-minute electrical calls, is part of how we work. We answer the phone. We book the work. We keep it simple.
Some electrical problems are straightforward to locate because they are always present. Others only appear when it rains, when a specific appliance runs, or when the load on a circuit reaches a certain point. A breaker that trips once a week under no obvious pattern, a light that flickers only in wet weather, an outlet that works fine until the air conditioning kicks on. These are harder to diagnose because the fault is not always visible when someone is standing in front of it.
Finding an intermittent fault means understanding the whole circuit, not just the point where the symptom shows up. A loose connection deep in a junction box can behave perfectly under a light load and fail under a heavier one. Water intrusion at an exterior fitting can cause a fault that clears when the weather does. We work through the circuit systematically rather than replacing the most obvious component and hoping the problem goes away. That approach takes longer up front and costs less in the long run.
We're one phone call from getting your power right.
A property built decades ago was wired for the appliances of that era. A refrigerator, a few lights, a television. The homes in Mentone that have been updated over the years have often had circuits added as needed, sometimes by previous owners, sometimes by contractors who were solving a specific problem without looking at the whole picture. The result is a panel that may be full, circuits that are shared beyond their original design, and wiring that does not match what the property is now being asked to run.
When a new appliance, an EV charger, or a battery backup system needs a dedicated circuit, we start with a load calculation. That tells us whether the existing panel can carry the addition or whether an upgrade is part of the answer. In the high desert region, where air conditioning runs continuously through the summer and solar adoption has grown steadily, that calculation matters more than it did when the house was built. If the panel cannot take the load, we explain the options and what each one involves before any work is quoted.
We'll get the job wired and finished.
Properties on larger lots in this area often have well pumps or irrigation systems that run on their own circuits. A pump circuit that trips under load, a controller that has lost its dedicated supply, or an irrigation system that was added without a proper circuit to feed it are all situations we handle. The work involves confirming the circuit is correctly sized for the motor load, that the wiring to the pump is in good condition, and that the breaker protecting it matches what the equipment actually draws.
A three-way switch controls a light from two locations. A multi-location system does the same from three or more. When one switch in a system stops working, the wiring behind it is often the issue rather than the switch itself. We trace the circuit, identify the fault, and rewire or replace what needs replacing. If the goal is to add a new control point to an existing circuit, we run that too.
A safety inspection covers the panel, the branch circuits, the grounding and bonding, and the presence of GFCI and AFCI protection where current code requires it. Older homes in this area often have a mix of wiring generations, and an inspection identifies where the risks are concentrated before any decisions about repairs or upgrades are made. We provide a clear account of what we find and what it means, so the property owner has a real picture of the electrical condition rather than a list of line items to approve sight unseen.
When knob-and-tube wiring is still in place, or aluminum branch-circuit wiring is present throughout the home, targeted repairs address symptoms without fixing the underlying condition. A rewire brings the wiring up to current standards across the whole property or in the sections where the risk is greatest. Partial rewiring makes sense when the problem is concentrated in one area and the rest of the home is sound. We protect your floors and finishes while we work, so the job does not leave the house looking worse than when it started.
Recessed and LED lighting upgrades, ceiling fan installation, dedicated appliance circuits, exterior lighting, and code-compliant wiring throughout are all part of what a rewire or partial rewire can address at the same time. We're ready to get your circuits working again.
We cover Mentone and the surrounding communities across San Bernardino County. That includes Redlands, Yucaipa, Highland, Calimesa, and Loma Linda. If you are in any of these areas and need electrical work scheduled, call and we will confirm coverage at your address.
The work is the same across the region: diagnose the fault, scope the repair, quote it before anything starts, and get it done to the code inspectors here enforce. Whether the property is in Mentone or a neighboring town, the process is the same.
That depends on what was installed and how. Some DIY work can be brought up to code with corrections. Other installations need to come out because the wiring method, the box, or the circuit is not safe or code-compliant as installed. We assess what is there and explain the options before any work is quoted.
The invoice goes to whoever authorized the work. On a managed property, that is typically the property manager or the owner, not the tenant. We confirm the billing contact when the job is booked so there is no confusion after the work is done.
Whether a permit is required depends on the scope of the work and the jurisdiction covering the property. We confirm what applies to your address before the work starts. When a permit and inspection are required, we handle the coordination as part of the project so the work is closed out correctly. You do not need to sort out the permit process separately.
Yes. Well pump circuits and irrigation supply circuits are jobs we take on. The work involves confirming correct breaker sizing, checking the wiring condition between the panel and the pump or controller, and making sure the circuit is protected and grounded properly. Call and describe the setup and we will scope it from there.
Yes. Older homes with knob-and-tube wiring, aluminum branch circuits, or ungrounded two-prong outlets are common in this area, and we handle the full range of repairs and upgrades those properties need. The approach depends on what is present and where the risk is concentrated. We explain the options on the call before any work is quoted.
If there is something in your electrical system that has not been right for a while, that is the call to make.
Call Apple Valley Electrical Company at (442) 419-3289 between 5:30 AM and 10:30 PM, any day of the week.
Describe what you are seeing, get the scope and the price on the call, and decide from there. We handle the older-property wiring problems, the intermittent faults, the panel that has run out of room, and everything in between.
Browse our full service area. Electrical work also reaches these towns: Redlands, Yucaipa, Highland, Calimesa.
From a dead outlet to a full panel replacement, we handle the electrical work that keeps homes and businesses in Mentone running safely. Call us, describe the job, and you get a price before anything is scheduled. We are open 5:30 AM to 10:30 PM, seven days a week, and we take urgent calls alongside scheduled work.
| Type of Work | What's Included | Ideal For | What to Keep in Mind |
|---|---|---|---|
| Dedicated Appliance Circuits |
| Homeowners adding major appliances or equipment that requires its own circuit | Running a high-draw appliance on a shared circuit causes nuisance tripping and can shorten equipment life. A dedicated circuit solves both problems. |
| Whole-Home Surge Protection |
| Homes with electronics, appliances, or equipment vulnerable to voltage spikes | Summer storm activity in the high desert can send voltage spikes through the lines. Installing surge protection at the panel level covers every circuit in the home at once. |
| Electrical Panel & Service Upgrades |
| Homes adding major appliances, EV chargers, solar systems, or running near panel capacity | A load calculation before the upgrade confirms the right panel size for what the home actually draws, not just what it drew years ago. |
Call (442) 419-3289 to describe the job, get a price, and get it on the schedule. We are available 5:30 AM to 10:30 PM, seven days a week.
(442) 419-3289